R&S ZNA26 - Page 678

GUI reference
R&S
®
ZNA
678User Manual 1178.6462.02 ─ 20
Load File
Load DUT + test fixture data from file
Remote command:
CALCulate:FMODel:EZD<Ph_pt>:DUT:MEASure:FILename
CALCulate:FMODel:EZD<Ph_pt>:DUT:MEASure:FILename:CLEar
CALCulate:FMODel:ISD<Ph_pt>:DUT:MEASure:FILename
CALCulate:FMODel:ISD<Ph_pt>:DUT:MEASure:FILename:CLEar
CALCulate:FMODel:SFD<Ph_pt>:DUT:MEASure:FILename
CALCulate:FMODel:SFD<Ph_pt>:DUT:MEASure:FILename:CLEar
Measure
Starts the measurement of DUT + test fixture at the Active ports.
The display area shows all the S parameter measurements being made. The resulting
Touchstone file is written to C:\Users\Public\Documents\Rohde-Schwarz\ZNA\Embed-
ding.
Remote command:
CALCulate:FMODel:EZD<Ph_pt>:DUT:MEASure
CALCulate:FMODel:ISD<Ph_pt>:DUT:MEASure
CALCulate:FMODel:SFD<Ph_pt>:DUT:MEASure
Active
Before starting to Measure, use these checkboxes to indicate the physical ports to
which DUT + test fixture are connected. For single-ended deembedding, 2 ports must
be active, for balanced deembedding 4 ports.
Remote command:
CALCulate:FMODel:EZD<Ph_pt>:DUT[:STATe]
CALCulate:FMODel:ISD<Ph_pt>:DUT[:STATe]
CALCulate:FMODel:SFD<Ph_pt>:DUT[:STATe]
Offset Embed softtool