R&S ZNA26 - Page 942

Command reference
R&S
®
ZNA
942User Manual 1178.6462.02 ─ 20
CALCulate:FMODel:EZD<Ph_pt>:DUT[:STATe] <Boolean>
Suffix:
<Ph_pt>
.
Parameters:
<Boolean>
Manual operation: See "Active" on page 678
CALCulate:FMODel:EZD<Ph_pt>:GENerate:SIDE<1|2> <Boolean>
The EZD tool can create fixture deembedding data at side 1, at side 2, or at both sides.
Suffix:
<Ph_pt>
.
<1|2> Side
Parameters:
<Boolean> ON (1)
Create fixture deembedding data at the specified side (<1|2>)
OFF (0)
Do not create fixture deembedding data at the specified side
(<1|2>)
Options: R&S ZNA-K210
Manual operation: See "Generate Side 1/Generate Side2" on page 686
CALCulate:FMODel:EZD<Ph_pt>:IMPedance <Boolean>
Suffix:
<Ph_pt>
.
Parameters:
<Boolean>
Manual operation: See "Impedance Corrected/Impedance Correction Settings"
on page 687
CALCulate:FMODel:EZD<Ph_pt>:IMPedance:BWIDlimit <Value>
Suffix:
<Ph_pt>
.
Parameters:
<Value> Default unit: Hz
Manual operation: See "Impedance Corrected/Impedance Correction Settings"
on page 687
SCPI command reference