R&S ZNA26 - Page 943

Command reference
R&S
®
ZNA
943User Manual 1178.6462.02 ─ 20
CALCulate:FMODel:EZD<Ph_pt>:IMPedance:REFerence <Value>
Suffix:
<Ph_pt>
.
Parameters:
<Value> Default unit: Ohm
Manual operation: See "Impedance Corrected/Impedance Correction Settings"
on page 687
CALCulate:FMODel:EZD<Ph_pt>:PORT:ORDer <PortOrder>
Tells the EZD tool about the port ordering of the test fixture.
Suffix:
<Ph_pt>
.
This suffix is ignored.
Parameters:
<PortOrder> ODD | NON
ODD: odd ports are on the left and even ports are on the right
NON: ports 1 to N are on the left and ports N+1 to 2·N are on
the right
Options: R&S ZNA-K210
Manual operation: See "Port Order" on page 686
CALCulate:FMODel:EZD<Ph_pt>:PRESet
Restores the default settings of the EZD tool.
Suffix:
<Ph_pt>
.
This suffix is ignored.
Usage: Event
Options: R&S ZNA-K210
Manual operation: See "Reset to Default" on page 675
CALCulate:FMODel:EZD<Ph_pt>:RUN:RUN
Runs the EZD tool.
Before executing this command, make sure that:
●
The test coupon measurement (using CALCulate:FMODel:EZD<Ph_pt>:
COUPon:MEASure) finished successfully, or the test coupon data were success-
fully loaded from file (using CALCulate:FMODel:EZD<Ph_pt>:COUPon:
MEASure:FILename
●
The measurement of DUT + test fixture (using CALCulate:FMODel:
EZD<Ph_pt>:COUPon:MEASure) finished successfully.
SCPI command reference