R&S ZNA26 - Page 939

Command reference
R&S
®
ZNA
939User Manual 1178.6462.02 ─ 20
OFF (0)
Display all traces in a single diagram.
Options: R&S ZNA-K231
Manual operation: See "Trace" on page 701
CALCulate:FMODel:DELT:TDR <Boolean>
If the Time domain analysis option R&S ZNA-K2 is installed, this command allows you
to add the TDR-based converted impedance traces to the recommended trace configu-
ration.
Parameters:
<Boolean> OFF (0)
TDR-based impedance traces added
ON (1)
TDR-based impedance traces not added
*RST: OFF
Options: R&S ZNA-K231
Manual operation: See "Trace" on page 701
CALCulate:FMODel:EZD...
Commands for Eazy Deembedding (see Chapter 4.7.14, "Eazy de-embedding based
on IEEE 370", on page 268).
CALCulate:FMODel:EZD<Ph_pt>:COUPon:MEASure
For a fixture modeling with the Easy De-embedding (EZD) tool, this command starts
the measurement of the symmetrical 2xThru coupon at the active ports (see
CALCulate:FMODel:EZD<Ph_pt>:COUPon[:STATe] on page 940).
Suffix:
<Ph_pt>
.
This suffix is ignored.
Usage: Event
Options: R&S ZNA-K210
Manual operation: See "Measure / Measure Open / Measure Short" on page 676
CALCulate:FMODel:EZD<Ph_pt>:COUPon:MEASure:FILename <String>
For a fixture modeling with the EZD tool, this command loads the coupon properties
from a Touchstone file.
Suffix:
<Ph_pt>
.
This suffix is ignored.
SCPI command reference