R&S ZNA26 - Page 944

Command reference
R&S
®
ZNA
944User Manual 1178.6462.02 ─ 20
The resulting Touchstone files are written to C:\Users\Public\Documents\Rohde-
Schwarz\ZNA\Embedding. If result files with the same name already exist, they are
overwritten.
Suffix:
<Ph_pt>
.
This suffix is ignored
Usage: Event
Options: R&S ZNA-K210
Manual operation: See "Run <Fixture Modeling Tool>" on page 679
CALCulate:FMODel:EZD<Ph_pt>:RUN[:STATe]
<Boolean>
For a fixture modeling with the EZD tool, this command allows to specify the ports to
which the deembedding files shall be assigned after the tool has run.
Suffix:
<Ph_pt>
.
Physical port number for single-ended deembedding, logical port
number for balanced deembedding.
Parameters:
<Boolean> 1 (ON) , 0 (OFF) otherwise
ON (1)
if a deembedding file shall be assinged to port <Ph_pt>
OFF (0)
otherwise
Options: R&S ZNA-K210
Manual operation: See "Apply" on page 680
CALCulate:FMODel:ISD...
Commands for AtaiTec's In Situ De-Embedding (ISD) tool, see http://ataitec.com/prod-
ucts/isd/
CALCulate:FMODel:ISD<Ph_pt>:ATTenuation:BEHavior....................................................945
CALCulate:FMODel:ISD<Ph_pt>:COUPon:MEASure........................................................ 945
CALCulate:FMODel:ISD<Ph_pt>:COUPon:MEASure:FILename.........................................946
CALCulate:FMODel:ISD<Ph_pt>:COUPon:MEASure:FILename:CLEar...............................946
CALCulate:FMODel:ISD<Ph_pt>:COUPon:MEASure:OPEN.............................................. 946
CALCulate:FMODel:ISD<Ph_pt>:COUPon:MEASure:OPEN:FILename...............................946
CALCulate:FMODel:ISD<Ph_pt>:COUPon:MEASure:SHORt............................................. 947
CALCulate:FMODel:ISD<Ph_pt>:COUPon:MEASure:SHORt:FILename..............................947
CALCulate:FMODel:ISD<Ph_pt>:COUPon:TYPE..............................................................947
CALCulate:FMODel:ISD<Ph_pt>:COUPon[:STATe]........................................................... 948
CALCulate:FMODel:ISD<Ph_pt>:DCEXtrapolat................................................................ 948
CALCulate:FMODel:ISD<Ph_pt>:DUT:MEASure............................................................... 948
CALCulate:FMODel:ISD<Ph_pt>:DUT:MEASure:FILename................................................949
CALCulate:FMODel:ISD<Ph_pt>:DUT:MEASure:FILename:CLEar......................................949
CALCulate:FMODel:ISD<Ph_pt>:DUT:TYPE.....................................................................949
SCPI command reference