R&S ZNA26 - Page 838

GUI reference
R&S
®
ZNA
838User Manual 1178.6462.02 ─ 20
For devices that are not autoconfigured by the analyzer firmware, "+" copies the device
to the table of Configured Devices.
Remote command:
n/a
Configured Devices
Table with all generators in use with their properties. The properties of manually config-
ured devices (using Add Device) can be changed in the dialog.
The following symbols indicate the status of the respective device:
●
– The device is online (connected, switched on, ready to be used)
●
– Communication error
In this case, check whether the device is properly connected to the configured
interface.
Remote command:
SYSTem:COMMunicate:RDEVice:GDEVice<Gdev>:DEFine
SYSTem:COMMunicate:RDEVice:GDEV<Gdev>:DELete
SYSTem:COMMunicate:RDEVice:GDEVice:DELete:ALL
SYSTem:COMMunicate:RDEVice:GDEVice:CATalog?
Scan Instruments
Performs an autodetection of "Known Devices" on the supported interfaces.
Note: Unintentional switchover to remote control
When using the NI-VISA library, ensure that the network analyzer itself is not listed as
a network device in the Measurement & Automation Explorer. Otherwise, "Scan Instru-
ments" sends an identification query (*IDN?), causing the analyzer to close the "Exter-
nal Generators" dialog (without executing "Scan Instruments") and to activate the
remote screen.
Remote command:
n/a
LAN Detection
Activate "LAN Detection" to include the LAN interface in the autodetection sequence
(see Scan Instruments).
Note: "LAN detection" only works for external devices sharing the IP subnet with the
R&S ZNA.
As a prerequisite, the R&S ZNA must accept incoming connections on UDP port 2473.
If necessary, add a corresponding inbound rule to your firewall settings.
Remote command:
n/a
Add Device
Opens the "Add Generic Device" dialog that allows you to configure the connection to
a generic device that was not auto-detected. The configured device is added to the list
of "Configured Devices".
Setup softtool