Preparing for Use
R&S
®
ZNLE
20Getting Started 1323.2873.02 ─ 07
Switching users when using the automatic login function
Which user account is used is defined during login. If automatic login is active, the
login window is not displayed. However, you can also switch the user account to
be used when the automatic login function is active.
1. Select the "Windows" icon in the toolbar to access the operating system of the
R&S ZNLE (see also Chapter 4.2.4, "Accessing the Start Menu",
on page 21).
2. Press [CTRL + ALT + DEL], then select "Sign out".
The "Login" dialog box is displayed, in which you can enter the different user
account name and password.
Deactivating the automatic login function
To deactivate the automatic login function, perform the following steps:
1. Log in to the R&S ZNLE operating system using an administrator account
(see "Switching users when using the automatic login function" on page 20).
2. Select the "Windows" icon in the toolbar to access the operating system of the
R&S ZNLE (see also Chapter 4.2.4, "Accessing the Start Menu",
on page 21).
3. In the "Start" menu, select "Run".
The "Run" dialog box is displayed.
4. Enter the command
C:\Users\Public\Documents\Rohde-Schwarz\ZNL\user\
NO_AUTOLOGIN.REG.
5. Press the [ENTER] key to confirm.
This command deactivates the automatic login function. The next time you
switch on the instrument, the operating system prompts you to enter your user
name and password before it starts the firmware.
Windows Operating System
To Next Page
Loading...
