Rane SL3 - Sample Player

SampLe pLayeR
The Sample Player allows you to play up to
six sources of audio, in addition to the tracks
playing on the virtual decks. Any audio le in
your Scratch Live library can be loaded to any
one of the 6 slots, allowing playback of short
samples, sound effects, or full length tracks.
The Sample Player displays the Song Title of
the track, along with a progress bar to indicate
the current playhead position.
The Sample Player is enabled when the SL 3
hardware is plugged in, however this is not
operational in the ofine player mode.
Select the Sample Player button to access
the SP-6 window. To load an audio le, drag and
drop the desired le from your library into one of
the slots.

Pressing the Play button on each slot will play the
loaded audio. Play will start from the beginning
of the le, unless a cue point or loop is set.
When play is pressed, the audio plays through
until the end of the track. Pressing play again
stops the audio.

  
  

StaRt pOInt
Play will begin from either the beginning of the
audio le, or the rst cuepoint, if the le contains
one.
Both of these options are overridden if the le
contains a loop. The le will then start from the
inpoint of the loop.
You can rene the start point for each piece of
audio by setting Scratch Live cue points in the
same way you would to any track. Simply load
the audio to a virtual deck, set your cue point,
then load it back into the Sample Player.


mIdI
The Sample Player is MIDI assignable. For full
functionality, the Sample Player window must be
opened rst before enabling MIDI assign mode.

RANE SL 3 FOR SERATO SCRATCH LIVE • OPERATOR’S MANUAL 1.8.4
18