23
You will need the following equipment to complete the cooker installation
satisfactorily
GAS PRESSURE TESTER FLEXIBLE GAS HOSE
Must be in accordance
with the relevant
standards. For LP Gas it
should be suitable for LPG,
capable of 50mbar
pressure, 70°C
temperature rise and carry
a red stripe, band or label
MULTIMETER
(for electrical checks)
You will also need the following tools:
1. Electric drill
2. Masonry drill bit
(only required if fitting the cooker on a stone or concrete floor)
3. Rawlplugs
(only required if fitting the cooker on a stone or concrete floor)
4. Steel tape measure
5. Cross head screwdriver
6. Flat head screwdriver
7. Spirit level
8. Pencil
9. Adjustable spanner
10. Screws for fitting stability bracket
STABILITY BRACKET
If the cooker is to be
supplied with gas through
a flexible hose, a stability
bracket or chain must be
fitted.
These are not supplied
by with the cooker but
are available at most
builders merchants.
To Next Page
Loading...
