INSTALLATION
Check the appliance is electrically safe and gas sound when you have nished.
34
ArtNo.350-0011 - Fitting the plinth 2 (Kitchener)
Outer plinth
Outer plinth xing screw
Inner plinth
ArtNo.350-0010 - Fitting the plinth 1 (Kitchener)
Final Fitting
Fitting the 1-piece Plinth (Professional+)
Loosen the three screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw. Twist
and t each end keyhole over their respective screws. Tighten
the xing screws (Fig. 10.15).
Fitting the 2-piece Plinth (Classic and Kitchener)
Fit the inner plinth to the bottom front of the cooker using
the 4 or 5 screws provided (Fig. 10.16).
Fit the outer plinth (2 screws, 1 each end) to the inner plinth.
The height of the outer plinth can be adjusted by sliding it up
or down via the slotted hole (Fig. 10.17).
Final Checks
Hotplate Check
Check each burner in turn (refer to the ‘Hotplate Burners’
section at the front of the instructions).
Grill Check
Turn on the grill and check that the grill heats up.
Oven Check
Set the clock as described earlier in the instructions, and then
turn on the ovens. Check that the that the oven burners light
and start to heat up.
Note: The oven light bulb is not included in the guarantee.
Turn o the ovens.
Customer Care
Installer: Please complete your details in this guide, inform
the user how to operate the cooker and hand over the
instructions.
Thank you.
Fig. 10.15
Fig. 10.16
Fig. 10.17
To Next Page
Loading...
