DST-64T / DST642D Wheel Balancers 19 P/N 5900192 — Rev. F — March 2021
Tighten securely, but do no overtighten.
Run the Cable coming off the Outer Arm through the clips on the underside of the Outer Arm
Mount Bar, then connect the fitting on the end of the cable to the Connector on the right side of
the Mount Box.
Installing the Shaft
The Shaft holds the Wheels you are balancing.
Tip Consider having two people on hand to install the Shaft: one person to hold the Shaft
Assembly in place while the second person screws in the Mounting Bolt. Have some rags
nearby; the Shaft comes greased to protect it during transport.
To install the Shaft:
Locate the Shaft Assembly and the Mounting Bolt from the parts supplied with the Balancer.
Clean the Shaft Assembly by removing the shipping grease and any debris that has accumulated.
Put the Shaft Assembly into place next to the Shaft Housing and hold it there.
Note: It is easier to install the Shaft with two people.
Put the Mounting Bolt into the end of the Threaded Shaft and begin tightening it.
Before fully tightening the Mounting Bolt, make sure the Alignment Marks (witness marks) are
aligned (see drawing below).
Not necessarily to scale. Not all components shown.
Tighten the Mounting Bolt into place.
To Next Page
Loading...
Need help?
General
