DST-64T / DST642D Wheel Balancers 34 P/N 5900192 — Rev. F — March 2021
Dynamic Balancing
Dynamic Balancing balances a steel Wheel on both the Inner and Outer Edges.
If the Wheel is out of balance, Clip-On Weights can go on the Inner Edge, the Outer Edge, or both.
To Balance a Wheel using Dynamic Mode:
Make sure you are dressed appropriately: leather gloves, steel-toed work boots, back belts,
hearing protection, and ANSI-approved eye protection: safety glasses, face shield, or goggles.
Visually inspect the Balancer to make sure everything is in place. The Hood should be
up
.
Make sure the Wheel you want to balance is both
clean
and
free of any weights
that may
have been put on previously.
If there are old weights on the Wheel, remove them. If the Wheel is dirty, clean it.
Mount the Wheel on the Balancer.
Refer to Mounting a Wheel for mounting instructions, if needed.
Turn the Balancer Off and then back On, to reset it.
On power up, baL xx appears in the Inner and Outer Windows. The xx is a numeric value that
indicates the software version being used.
After a few seconds, default values appear in the Distance, Width, and Diameter Windows.
To Next Page
Loading...
Need help?
General
