DST30P Wheel Balancer 10 P/N 5900163 — Rev. C1 — March 2020
Installation Checklist
Following are the steps needed to install the Balancer. Perform them in the order shown.
☐ 1. Review the installation Safety Rules.
☐ 2. Plan for Electrical Work.
☐ 3. Make sure you have the necessary Tools.
☐ 4. Select the Installation Site.
☐ 5. Make sure there is adequate Clearance on all Sides.
☐ 6. Unpack the Components.
☐ 7. Identify the Components on the Back of the Unit.
☐ 8. Install the Control Panel.
☐ 9. Install the Hood.
☐ 10. Install the Shaft.
☐ 11. Anchor the Unit.
☐ 12. Connect to a Power Source.
Requires a licensed, certified Electrician
.
☐ 13. Test the Balancer.
To Next Page
Loading...
