DST30P Wheel Balancer 3 P/N 5900163 — Rev. C1 — March 2020
Table of Contents
Introduction 3 Operation 23
Shipping Information 4 Maintenance 39
Safety Considerations 4 Troubleshooting 40
Components 6 Wiring Information 43
FAQ 8 Labels 44
Specifications 9 Parts 46
Installation Checklist 10 Maintenance Log 58
Installation 11
Introduction
This manual describes the BendPak Ranger DST30P Wheel Balancer, which is a computer-controlled
Wheel Balancer that provides fast, accurate Wheel balancing for a wide variety of Wheels.
More information about BendPak Ranger products is available at rangerproducts.com.
This manual is mandatory reading for all users
of the DST30P, including anyone who sets
up, operates, maintains, or repairs it.
⚠ DANGER Be very careful when setting up, operating, maintaining, or repairing this equipment;
failure to do so could result in property damage, product damage, injury, or (in very
rare cases) death. Make sure only authorized personnel operate this equipment. All
repairs must be performed by an authorized technician. Do not make modifications
to the unit; this voids the warranty and increases the chances of injury or property
damage. Make sure to read and follow the instructions on the labels on the unit.
Keep this manual on or near the equipment so that anyone who uses or services it can read it.
Technical support and service for your Wheel Balancer is available from your distributor or by calling
BendPak Ranger at (805) 933-9970. You may also call regarding parts replacement (please
have the serial number and model number of your unit available).
To Next Page
Loading...
