5
6. Brakes
a. V-brakes
To disconnect the V-brakes (for example, if you need to remove the wheel from the frame),
release the curved metal brake cable guide from the cable bridge on the brake arms. Push the
brake arms together and press the brake pads against the rim to create sufficient slack in the
brake cable. Lift the cable guide out of the cable bridge. If there is insufficient slack to release
the cable guide, turn the cable adjustment bolt on the brake lever clockwise with your right hand
to release the brake cable tension.
To reconnect the V-brakes, press the brake arms together and place the curved metal cable
guide back into the cable bridge. Make sure that the brake cable head is properly seated in the
brake lever on the handlebars and the brake cable moves freely when the brake lever is pulled.
Do not forget to re-tighten the cable adjustment bolt on the brake lever, ensuring that there is
sufficient tension in the brake cable without the brake pads rubbing on the rim
CAUTION: Before every ride, check the brakes work properly. If you are in any doubt, contact
your RASCAL dealer or RASCAL Bikes service centre.
b. Hydraulic Brakes
Hydraulic disc brakes do not have to be disconnected to remove the wheel. Use a plastic spacer
between brake pads (when the wheel is removed) to prevent the brake pads from coming
together by accident. Avoid pulling the brake lever when the wheel is removed, and a spacer is
not installed.
CAUTION: Always check the brakes before riding. If you are in any doubt, contact your RASCAL
dealer or RASCAL Bikes service centre.
BAD WEATHER WARNING
Always be aware that brakes do not work as efficiently in wet weather as in dry conditions. In
wet conditions, even well-maintained brakes require a longer distance to stop. Therefore, teach
your child to be more careful when riding in wet conditions and equip them with lights and
reflectors for better visibility.
7. Wheel Rims, Brake Pads and Discs
Dirty or greasy rims, rotors and brake pads can significantly reduce the efficiency of brakes. To
clean the rims or rotors, wipe them with a clean cloth or wash them with soapy water, rinse
thoroughly and let them dry. If the rims or rotors are greasy or have oily marks on, clean them
with a bicycle disk brake cleaner.
The same maintenance applies to the brake pads. When lubricating the chain or suspension
forks, be careful not to spill the lubricant on the rims, rotors or brake pads. If this happens, use a
bicycle-specific degreaser to clean all traces of the lubricant before riding. If the brake pads are
worn, they must be replaced.
Do not use solvents to clean greasy components!
To Next Page
Loading...