Maintenance and repair
99
9
9.4 Wartungsplan
This chapter specifies the maintenance tasks to be undertaken.
9.4.1 Maintenance
NOTICE
Notes on the lubrication and lubrication intervals are provided in chapter
9.14: Lubrication plan, page 119
.
Assembly Task Note
Safety equipment Check function before starting the dri-
ve
Page 102
hydraulics Check for damages/leaks Page 113
Screw connections Regularly check tightness
Check condition
retighten as necessary
Page 96
Wear parts Regularly check condition and replace
as necessary
Page 96
Entire fertiliser spreader Clean Page 101
Protective grid mounting
in hopper
Is the protective grid in place? Check
function and adjust the protective grid
lock as necessary
Page 102
Spreading disc Check condition and replace the
spreading disc or apply corrosion pro-
tection as necessary
Spreading vane Check condition and replace the
spreading vane or apply corrosion
protection as necessary
Page 107
Spreading disc hub Check the position and clearance to
the agitator and correct as necessary
Page 104
Agitator Check function of eccentric drive,
check connecting rods for tightness
and damage, check locking direction
and free running of agitator heads,
check agitator fingers for wear
Page 105
Metering slide Check the correct metering slide
opening and adjust as necessary. Re-
calibrate the metering slide test points
of the electronic control unit.
Page 109
To Next Page
Loading...
