Maintenance and repair
107
9
9.9 Spreader vane replacement
Replace worn spreader vanes.
Requirements:
The spreading discs have been dismounted (see section “Dismounting and
mounting spreading discs”).
Determination of spreader vane type:
Figure 9.10: Spreading disc label
[1] Spreading disc type
[2] Spreader side
[3] Length of the spreader vane
[4] Coating
NOTICE
Worn spreader vanes must only be replaced by your dealer or your specialist
workshop.
n CAUTION
Conformity of the spreader vane types
The type and size of the spreader vanes are adapted to the
spreading disc. Incorrect spreader vanes can cause damage to the
machine and the environment.
ONLY use spreader vanes which are approved for the rele-
vant disc.
Compare the labelling on the spreader vane. The model
and size of the new and old spreader vane must be identi-
cal.
To Next Page
Loading...
