Rauch AXIS H 50.2 EMC + W - Commissioning; Tractor Requirements

Commissioning
43
7
7 Commissioning
7.1 Accepting the machine
When accepting the machine, please check the completeness of the delivery.
The standard equipment includes
 1 mineral fertiliser spreader of the AXIS H EMC series
 1 AXIS H EMC operator's manual
 1 fertiliser chart (on paper or CD),
 1 calibration kit comprising chute and calculator,
 Lower link and upper link pins,
 1 spreading disc set (according to order)
 1 agitator
 Protective grid in hopper
 1 ISOBUS machine control unit
Please also check any optional equipment that you ordered.
Check for any shipping damage or missing parts. Have any transportation dam-
ages confirmed by the forwarding agent.
If in doubt, contact your salesperson or the manufacturer directly.
7.2 Tractor requirements
To ensure a safe and correct use of the machine of the AXIS H EMC series, the
tractor must meet the necessary mechanical, hydraulic, and electrical require-
ments.
 Oil supply: max. 210 bar, single or double-acting valve (depending on equip-
ment)
 Hydraulic performance depending on machine type: 45 - 65 l/min, constant
flow or load sensing system,
 Free return min. internal diameter of 18 mm,
 Operating voltage: 12 V,
 Three-point linkage, category II (AXIS H 30.2 EMC).
 Three-point linkage, category III (AXIS H 50.2 EMC).
NOTICE
When receiving the machine, check that all attached components are correctly
and securely tightened.
The right-hand spreading disc and left-hand spreading disc must be mounted
facing the direction of travel.