Rauch AXIS H 50.2 EMC + W - Adjusting the Drop Point; Checking the Mounting Height

Spreading operation 8
82
8.5.3 Adjusting the drop point
With the selection of the spreading disc type, a particular range for the working
width is defined. By altering the drop point, the working width can be accurately
set and adjustments to different fertiliser types can be made.
You can set the drop point via the upper scale plate.
 Adjusting in the direction of smaller numbers: The fertiliser is ejected
sooner. This results in spreading patterns for smaller working widths.
 Adjusting in the direction of larger numbers: The fertiliser is ejected later
and spread more towards the outside into the overlap zones. This results in
spreading patterns for larger working widths.
Figure 8.5: Adjustment centre for drop point
8.6 Checking the mounting height
NOTICE
The machine of the AXIS H EMC series is equipped with an electronic drop point
adjustment.
Electronic drop point control is described in a separate operator's manual of the
electronic control unit. This operator's manual is an integral part of the electronic
machine control unit.
NOTICE
Check if the preset mounting height is correct while the hopper is full.
 Take the mounting height setting values from the fertiliser chart.
 Observe the maximum admissible mounting height.
 See also “Presetting the mounting height“ on page 49.