Commissioning
51
7
7.4.3 Mounting heights A and B according to fertiliser chart
The mounting heights in the fertiliser chart (A and B) are always measured in the
field from the top of the crop height to the bottom edge of the frame.
Setting the mounting height during normal fertilisation
Requirements:
The machine is installed at the highest connecting point of the upper link at
the tractor.
The lower link of the tractor is installed at the upper coupling point of the
lower link of the machine.
Proceed as follows when determining the mounting height (in normal fertilisation):
1. Determine the mounting heights A and B (above crop height) from the fertil-
iser chart.
2. Compare the mounting heights A and B plus the crop height with the maxi-
mum admissible mounting heights at the front (V) and rear (H).
NOTICE
The values of A and B can be taken from the fertiliser chart.
To Next Page
Loading...
