Spreading operation
85
8
Normal spreading in or out of the headland tramline
If you continue spreading in the field after headland tramline spreading:
Switch off boundary spreading.
Figure 8.7: Normal spreading
[A] End of spreading fan when spreading in the headland tramline
[E] End of spreading fan when spreading in the field
[T] Headland tramline
[X] Working width
The metering slides open or close at different distances to the field border of the
headland when travelling backwards and forwards.
NOTICE
If a GPS system and an ISOBUS machine control unit are applied for operation
of the machine, make sure that the machine control unit software supports the
OptiPoint function.
The OptiPoint function by RAUCH calculates the optimal switching-on and
switching-off point for spreading on the headlands based on the settings of the
mineral fertiliser spreader.
You can skip the information in the present paragraph since the OptiPoint
function assumes these settings.
Please refer to the operator's manual of the respective control unit.
E
A
X
To Next Page
Loading...
