Spreading operation 8
88
NOTICE
The VariSpread compatible machine is equipped with two electrical drop point
actuators. Via the ISOBUS machine control unit, the settings of the sections can
be defined to achieve accurate spreading results during spreading operation in
wedge-shaped fields.
For further information on possible section settings, refer to the operator's
manual of the electronic control unit (AXIS H ISOBUS).
Figure 8.9: Display of the section status on the operating screen of the machine control unit
[1] Active sections with 4 possible spreading width steps
[2] The right section is reduced by 2 section steps
To Next Page
Loading...
