Raymarine 150G - User Manual

T150/150G/T400/400G Course Computers
Type 150/150G/400/400G Course Computers Service Manual 83156-1 1
Type 150/400 Course Computers
T150, 150G, T400 and 400G
Autopilot Course Computers
Service Manual
Document Number: 83156-1
Date: July 2002
Course Computer core packs
(including compass and rudder reference)
E12054, T150 core pack
E12055, T400 core pack
E12091, 150G core pack
E12092, 400G core pack
Course Computer only
E15013, T150 Course Computer
E15014, T400 Course Computer
E15015, 150G Course Computer
E15016, 400G Course Computer
WARNING:
CE Marking of Equipment/Replacement Parts
If the Raymarine equipment under repair, test, calibration, installation or setting to work carries the European CE mark,
only parts and components supplied or approved for such use by Raymarine should be used in order to maintain
compliance with the relevant CE requirements.
Incorporation, use or attachment, by any means, of parts or components not supplied for or not approved for such use by
Raymarine or, if supplied or approved for use by Raymarine, not properly fitted in accordance with instructions
published, provided or recommended by Raymarine, may cause the equipment to malfunction and, in particular, to
become unsafe or to no longer meet the relevant CE requirements. In these circumstances, Raymarine excludes liability
to the fullest extent permissible in law for any loss or damage including any liability for its contribution to such loss or
damage by its negligent acts or omissions.

Summary

Main Parts and Spares for Autopilot Course Computers

Functional Tests for Autopilot Course Computers

Initial Inspection Checks

Outlines essential visual checks before applying power to the Course Computer.

Detailed Diagnosis Procedures

Guides through a series of detailed tests for diagnosing Course Computer faults.

Disassembly and Reassembly of Course Computers

Course Computer Disassembly Steps

Provides step-by-step instructions for taking apart the Course Computer.

Course Computer Reassembly Steps

Provides step-by-step instructions for putting the Course Computer back together.

Removing and Fitting the GyroPlus Yaw Sensor

Course Computer Re-calibration Post-Installation

Explains the mandatory re-calibration required after sensor installation.

PCB Details for Autopilot Course Computers

Inputs and Outputs on Terminal Blocks

List of PCB Components

Lists PCB components with part numbers, descriptions, and PCB references.

Software Upgrade Procedure for Course Computers

Connecting the Course Computer to a PC

Step-by-Step Software Upgrade Process

Provides step-by-step instructions for upgrading the Course Computer software.

Raymarine 150G Specifications

General

Product Name	Raymarine 150G
Category	Autopilot System
IP Rating	IPX6
Interface	NMEA 0183, NMEA 2000
Heave Accuracy	5%