RayTech Navigator User’s Guide
4-8
2. Type in a name (up to 13 characters including blanks) for
your route, or click OK to accept the default name of “Qr.”
Note: Identical route names will overwrite each other
without a confirmation warning.
3. Click OK. The Standard cursor changes to the Route
cursor (Figure 4-8). Move the cursor over the area
where you want the route to begin, then left-click the mouse.
The route is started, and the name you chose along with range
and bearing of the first leg is displayed (Figure 4-8).
Figure 4-8. Beginning a Route
Route name appears at originating point and at each additional waypoint
Distance and bearing of leg appears between waypoints
Draw Route cursor
To Next Page
Loading...
