Need help?Do you have a question about the Raymarine Marine GPS System and is the answer not in the manual?
General| Brand | Raymarine |
|---|---|
| Model | Marine GPS System |
| Category | Marine GPS System |
| Language | English |
Lists minimum and recommended system requirements for the software.
Explains the process of installing the Navigator software.
Provides step-by-step instructions for installing from a CD.
Provides instructions for downloading and installing from the internet.
Describes how to install and load various chart types.
Details the process for installing MapTech PCX and NOAA/BSB Charts.
Explains how to plot and edit routes for navigation.
Provides steps for creating and naming a new route.
Covers managing routes and waypoints, including moving and deleting.
Explains how to use the various Radar functions within Navigator.
Describes the Pathfinder Panel toolbar and its functions.
Explains how to adjust the radar gain for optimal signal display.
Guides on using the Sea Clutter control to reduce wave returns.
Details how to use RAIN and FTC controls for clutter reduction.
Explains how to fine-tune the radar receiver for maximum returns.
Guides on measuring range and bearing using VRM/EBL.
Explains measuring range and bearing to targets from the vessel.
Details how to access and use VRM/EBL functions.
Introduces the Mini Automatic Radar Plotting Aid (MARPA).
Guides on how to acquire a target for MARPA tracking.
Explains how to remove a target from the MARPA database.
Explains how to display and use sonar data.
Describes the Pathfinder Panel functions for sonar.
Explains how to select the power setting for the transducer.
Describes the selection of 50 kHz and 200 kHz sonar frequencies.
Guides on adjusting display gain (sensitivity) for sonar.
Explains how to display and use the A-Scope sonar image.
Describes how to display and use the Bottom Lock sonar feature.
Explains how to set up fish, shallow, and deep water alarms.
Explains how to place and manage waypoints on the sonar display.
Guides on using Polars for analyzing and tuning boat performance.
Describes the Polar Parameters screen for data input.
Explains the Data Tests screen for entering performance data.
Guides on graphing and reading Polar Plot screens.
Explains analyzing Polar plot aspects using specific plot screens.
Explains instrument calibration for ensuring data accuracy.
Guides on performing boat speed calibration.
Details procedures for compass deviation and heading error calibration.
Explains calibration of the apparent wind angle sensor.
Guides on calibrating the true wind angle measurement.
To Next Page