What to do if my Raymarine RAY90 Radio has no GNSS signal?
If your Raymarine Radio indicates an internal fault such as no GNSS signal, no antenna, or a lost signal, check the connection to the GNSS antenna and ensure there are no obstructions blocking the signal.
What to do if Raymarine Radio GPS sensor is initializing or not ready?
If the GNSS (GPS) sensor on your Raymarine Radio is initializing or not ready, allow time for the GPS sensor to initialize properly.
What to do if Raymarine Radio VHF transceiver module initializing / not ready?
If the VHF transceiver module on your Raymarine Radio is initializing or not ready, wait for the module to complete the initialization process.
What to do if Raymarine Marine Radio will not boot up and is stuck in a re-boot loop?
If your Raymarine Marine Radio is stuck in a re-boot loop, consider the following: * **Power Supply and Connection:** Refer to the solutions for the problem 'Product does not turn on or keeps turning off' for troubleshooting steps. * **Software Corruption:** In the event that the product's software has become corrupted, try re-flashing the latest software from the Raymarine website.
To Next Page
General
