Chapter 5: Operation 81
4. Initiate receiving of waypoints on the NMEA compatible equipment.
5. Select WPT/ROUTE TRANSFER.
The waypoint transfer functions are displayed:
6. Select SEND WAYPOINTS and press ENTER; the text changes to
STOP SENDING.
7. To stop waypoint transfer, press ENTER.
➤ To receive waypoints and route lists:
1. Display the Waypoint List as previously described, then select WPT/
ROUTE TRANSFER.
2. Select RECEIVE WAYPOINTS and press ENTER; the text changes to
STOP RECEIVING and remains selected.
3. Initiate sending waypoints on the NMEA compatible equipment.
4. To stop waypoint transfer, press ENTER.
Note: If either the Waypoint List or Route List becomes full, a warning is
displayed and the operation is terminated.
D4692-1
D4693-1
To Next Page
Loading...
Need help?
General