Chapter 4: Calibration
23
4.3 Intermediate calibration
Intermediate calibration enables you to:
• Check the instrument software version.
• Check and if necessary set, the instrument status - either MASTR
(master) or REPTR (repeater).
Follow the procedure in the Intermediate calibration flow diagram.
CAL
Note:
If there is no key activity when
the Software version screen
is displayed, calibration will
time out to normal operation
after 5 seconds,
Software
version
D4615-2
for approximately 4 seconds
hold down and
Instrument
status
During normal operation
for approximately 2 secondshold down and
To save your settings and return to normal operation from either screen,
INTERMEDIATE CALIBRATION
4.4 Dealer calibration
Dealer calibration enables you to set:
• User calibration on/off.
• Boat show mode on/off.
Dealer calibration also gives access to the Factory defaults screen.
This enables you to reapply the factory settings if you want to reset the
instrument to a known operating condition.
Follow the procedure in the Dealer calibration flow diagram.
157_2c04.p65 01/05/01, 12:2323
To Next Page
Loading...
