38 ST60 Tridata Instrument Owner’s Manual
9. Carry out a second calibration run (see sheet 2 of the Speed calibra-
tion flow chart), using the procedure described above in steps 4 to 8.
Note: At the end of this second run, the text End alternating with the new
calibration factor is displayed at the bottom of the screen.
10. Press the speed key to leave distance calibration and return to the
Instrument status screen.
from Speed
calibration - sheet 1
At the start of the
outward cal run
press
At the start of
the return cal
run press
At the end of the
outward cal run
press
At the end
of the return
cal run
press
Carry out the
outward leg of
the second
cal run
Carry out the
return leg of
the second
cal run
Press
to store cal factor
speed
Press
Speed calibration - sheet 2
D4421-1
to return to
Instrument status display
(Intermediate calibration)
depth
speed
speed
speed
speed
depth
Alternating
and
81040_1.book Page 38 Thursday, November 7, 2002 10:21 AM
To Next Page
Loading...
