27
Operation
Features
Your garage door opener is equipped with features to provide you with greater control over your garage door
operation.
ALERT2CLOSE
The Alert2Close feature provides a visual and an audible alert that an unattended door is closing.
TIMER-TO-CLOSE(TTC)
The TTC feature automatically closes the door after a specified time period that can be adjusted using a TTC
enabled door control. Prior to and during the door closing the garage door opener lights will flash and the
garage door opener will beep.
MYQ
myQ
®
technology uses a 900MHz signal to provide two-way communication between the garage door opener
and myQ
®
enabled accessories. Your garage door opener is compatible with up to 16 myQ
®
accessories.
SECURITY+ 2.0 REMOTE CONTROLSAND DOORCONTROLS
Your garage door opener has already been programmed at the factory to operate with your remote control,
which changes with each use, randomly accessing over 100 billion new codes. Compatible with myQ
®
and
Security+ 2.0 accessories, see page 37.
NOTE: Older Raynor remote controls, door controls, and third party products are not compatible.
SECURITY+2.0 Accessories MEMORY CAPACITY
Remote Controls Up to 12
Door Controls Up to 2 Smart Control Panels or 4 of any other Security+ 2.0 door
controls
Keyless Entries Up to 1
THE PROTECTORSYSTEM
®
(SAFETY REVERSING SENSORS)
When properly connected and aligned, the safety reversing sensors will detect an obstruction in the path of the
infrared beam. If an obstruction breaks the infrared beam while the door is closing, the door will stop and
reverse to full open position. If the door is fully open, and the safety reversing sensors are not installed, or are
misaligned, the door will not close from a remote control. However, you can close the door if you hold the
button on the door control or keyless entry until the door is fully closed. The safety reversing sensors do not
effect the opening cycle.
LIGHTS
The garage door opener light bulbs will turn on when the opener is initially plugged in; power is restored after
interruption, or when the garage door opener is activated. The lights will turn off automatically after 4-1/2
minutes. Use an incandescent A19 light bulb (100 watt maximum).
Light Feature
For added control over the light bulbs on your garage door opener, see page 30.
USING YOURGARAGEDOOROPENER
The garage door opener can be activated through a wall-mounted door control, remote control, wireless keyless
entry or myQ
®
accessory. When the door is closed and the garage door opener is activated the door will open. If
the door senses an obstruction or is interrupted while opening the door will stop. When the door is in any
position other than closed and the garage door opener is activated the door will close. If the garage door opener
senses an obstruction while closing, the door will reverse. However, you can close the door if you hold the
button on the door control or keyless entry until the door is fully closed. The safety reversing sensors do not
affect the opening cycle. The safety reversing sensor must be connected and aligned correctly before the
garage door opener will move in the down direction.
To Next Page
Loading...
Need help?
General
