Need help?Do you have a question about the Raytools XC3000S Series and is the answer not in the manual?
Illustrates bus type and pulse type servo connection methods for the XC3000S system.
Details Motion Control, IO Function, Work Environment, and Power Requirements.
Describes the features and specifications of the EPC-1020 HMI PC.
Details the EPC-2000 EtherCAT master PC's features, stability, and interface.
Outlines the EDS3000 EtherCAT slave interface board's IO, motion, and laser follow capabilities.
Explains servo control interfaces for X, Y, Y1, Z, and F axes, with pin definitions.
Covers wiring diagrams for various fiber laser types like Chuangxin, Hotspot, and Raycus.
Details the functional layout and ports of the EDS2010 interface board.
Specifies hardware requirements for a self-hosted XC3000S system installation.
Guides through the steps of installing the cutting software and its prerequisites.
Covers setting software parameters, saving configurations, and licensing procedures.
Details configuring axis parameters, limits, and return-to-origin settings.
Explains how to test axis limits and adjust servo gain using the diagnostic tool.
Guides on performing the return origin function and adjusting servo gain.
Identifies key areas of the platform configuration tool interface.
Describes functions available in the File, Config by types, Tool, and Help menus.
Explains PLC variable categorization and operations for linking hardware and software points.
Details operations for adding, inserting, deleting, and managing EtherCAT nodes.
Provides step-by-step examples for importing configurations and setting up machines.
Covers solenoid valve wiring with diodes and power supply specifications.
Provides methods for troubleshooting F-axis abnormalities and cutting head issues.
Addresses common issues like host entry failure and slave connection status.
Introduces the EDS2000 board's compatibility and features as an alternative to EDS3000.
Provides wiring diagrams and interface pinouts for the EDS2000 board.
Details the servo control interfaces and F-axis control connector for the EDS2000.
Presents wiring diagrams and parameter settings for various servo drive models.
General| Laser Type | Fiber Laser |
|---|---|
| Laser Power | 3000W |
| Cooling Method | Water Cooling |
| Weight | 23 kg |
| Wavelength | 1070 nm |
To Next Page
