Need help?Do you have a question about the Raytools BM115 Series and is the answer not in the manual?
Describes the components of the BM115 laser cutting head.
Details how to mount the BM115 to a machine tool.
Explains how to connect water and gas pipes to the cutting head.
Guides on connecting the cutting head to power and encoder cables.
Discusses the fiber interface and its connection.
Details the process of inserting and aligning the fiber optic cable.
Covers the installation and setup of the ETC-F100 auto-focus system.
Explains the setup for FSCUT (Cypcut) with position mode.
Details how to adjust the beam alignment for optimal cutting quality.
Guides on manually adjusting the focus position for initial setup or after component replacement.
Explains the procedure and frequency for cleaning lenses.
Covers the process of removing and installing various lenses.
Instructions for replacing the nozzle connector due to potential damage.
Provides troubleshooting steps for drive-related issues.
Analyzes common problems encountered with the system and their solutions.
General| Brand | Raytools |
|---|---|
| Model | BM115 Series |
| Category | Industrial Equipment |
| Language | English |
To Next Page
