Raytools BM110 Series

Need help?

Do you have a question about the Raytools BM110 Series and is the answer not in the manual?

Summary

Introduction

1.1 Product Features

Details the key characteristics and capabilities of the BM110 series laser cutting heads.

1.2 Structure & Function

Describes the main units and their functions within the laser cutting head.

Mechanical Installation

2.1 Mounting Holes

Details the mounting hole specifications and recommendations for installing the laser head.

2.2 Connection of Water Pipe and Gas Pipe

Explains how to connect water cooling channels to the laser cutting head.

2.2.1 Water-cooled interface

Details the specifications and requirements for the water-cooled interface.

2.2.2 Assist gas interface

Recommends specifications for cutting gas purity, water vapor, and hydrocarbons.

2.3 Connection of Cutting Head Cable

Details how to connect the cutting head cable to the machine and driver.

2.3.1 Connection of Cutting Head and Cable

Provides instructions for connecting the cutting head to its respective cables.

2.3.2 Connection of Cable and Driver

Explains how to connect the cables to the motor driver.

2.4 Fiber Input Interface

Describes the fiber interface compatibility and general connection principles.

2.5 Fiber Insertion and Interface Direction Adjustment

Provides instructions for inserting and adjusting the fiber optic connection with QBH connector.

Electrical Installation and Commissioning

3.1 FSCUT (BC) with position mode

Details the wiring and initial setup for the FSCUT (BC) system in position mode.

3.1.1 Wiring

Explains the wiring connections for the motor, power, and limit sensors.

3.1.2 Interface Operation

Explains how to operate the interface for J axis movement, homing, and parameter settings.

Adjustment of Beam Center and Focus Position

4.1 Beam Center Position Adjustment (QBH interface)

Guides on adjusting the beam center using the QBH interface for optimal cutting.

4.2 Beam Focus Position Adjustment

Provides steps for manually re-determining the focus position after lens or laser replacement.

Maintenance

5.1 Cleaning Lens

Explains the importance and procedure for regular cleaning of the laser cutting head lenses.

5.2 Removal and Installation of Lens

Details the general process for removing and installing lenses.

5.2.1 Removal and Installation of Protective Lens

Provides step-by-step instructions for removing and installing the protective lens.

5.2.2 Removal and Installation of Top Protective Lens

Guides on safely removing and installing the top protective lens assembly.

5.2.3 Removal and Installation of Collimating Lens

Details the procedures for removing and installing the collimating lens.

5.2.4 Removal and Installation of Focusing Lens

Provides steps for removing and installing the focusing lens.

5.3 Replace Nozzle Connection Assembly

Details how to replace the nozzle connection assembly.

5.3.1 Replace Ceramic Structure

Details how to replace the ceramic structure of the nozzle connection assembly.

5.3.2 Replace Nozzle

Provides instructions for replacing the nozzle and performing necessary calibration.

Mechanical and Optical Configuration

6.1 Physical Structure

Illustrates and describes the physical components and layout of the laser cutting head.

6.2 Optical Configuration

Details the optical specifications and configurations of the laser cutting head.

6.2.1 Collimation Length

Specifies the collimation focal distance for different QBH configurations.

6.2.2 Focus Length

Presents the focus length options for the laser cutting head.