6
PRE-RIDE CHECKLIST
Loose Parts/Tire Care
Check and secure all fasteners before every ride. Make
sure the collar clamp is locked properly in place before riding.
Inspect tires for signs of wear or damage. Measure and
adjust the PSI of the tires accordingly. Do not exceed 60 PSI.
Replacement Parts
Replace worn or broken parts immediately.
Call 1-866-467-2967 for parts or visit www.razor.com.
Safety Gear
Always wear proper protective equipment, such as an approved
safety helmet, elbow pads and kneepads. Always wear shoes
(lace-up with rubber soles) and keep shoelaces tied and out of
the way of the wheels. Never ride barefooted or in sandals.
Be Careful!
You will see people on TV and maybe even people you know doing
tricks and stunts. These are people who have been practicing on
scooters for a very long time. Don’t try something until you are
ready. Avoid steep inclines and don’t ride too fast — you can lose
control and fall. Skateboard parks are not designed for scooters.
Never ride in traffic or on the street and watch your surroundings
for pedestrians, bikers, boarders and skaters.
Maintain a hold on the handlebars at all times.
USAGE
How to Ride
Place one foot on the baseboard, push forward with the other foot. Steer with both hands on the handlebars.
For enhanced cornering, lean slightly into the direction of the turn. For controlled stops, apply the brake by stepping
on the rear brake. Razor recommends that you practice applying the brake at various speeds and in an open area
free from obstructions before riding your scooter around others.
To Next Page
Loading...
Need help?
General
