Razor Dirt Quad - Assembly and Set-Up; Battery Charging Procedure; Handlebar Attachment

ASSEMBLY AND SET-UP
1
Using the 6mm hexagonal
key wrench, remove bolts
from handlebar clamp.
2
Place handlebars in handle-
bar clamp
in upright
, vertical
position.
3
Insert bolts and tighten
securely. When properly
tightened, the handlebars
should not move forward or
back.
Note:
The gap between
the upper clamp and lower
clamp should be equal on both
sides of handlebar.
Attaching the Handlebars
WARNING:
Failing to properly adjust and
tighten the bolts that affi x the
handlebars
can cause you to
lose control and crash.
Charging the Battery
Your electric four wheeler may not have a fully charged battery; th
erefore it
is a good
idea
to charge the
battery prior to use.
•
I
nitial charge time: 12 hours
•
Run time: up to 40 minutes
•
Average battery life:
250 charge/discharge cycles
1
Align the groove on the p
lug
of the charger port
and plug
into the port on the Dirt Quad.
Tighten the threads to secure
the plug.
The charger works
with the power switch in either
the on or off position.
2
P
lug the charger plug into a
wall outlet.
WARNING:
A
lways disconnect
your electric
four wheeler from the charger
before cleaning with liquid.
Note:
If your charger does not
look like the one illustrated,
your unit has been supplied
with an alternative charger.
The specifi cations and charging
procedure would not change.
The charger has a small window
with one LED or two LEDs to
indicate the charge status. Refer
to the illustration on the charger
unit for the actual “charging” and
“charged” status indications for
your model charger.
C
hargers have built-in over-charge
protection to prevent battery from
being over-charged.
Be sure to properly align the
groove on the charger input
port with the corresponding
socket on the Dirt Quad and
tighten threads; otherwise, no
charging action will occur.
Charger
Plug
Charger
Port
3
•
Recharge time:
Always
remember to turn the
power switch off and recharge for at least 8 hours
after each use.
When vehicle is not in regular
use, recharge battery at least once a month until
normal use is resumed. If you have left the power
switch on or your product has not been charged
for a long period of time the battery may reach a
stage at which it will no longer hold a charge.