Razor Dirt Quad - Fuse and Chain Replacement

5
REPAIR AND MAINTENANCE
q
Replacing the Fuse
WARNING:
To prevent shock or short circuit,
please follow the instructions
accordingly and do not skip or
combine any steps.
2
Under the f
ront fender and
t
hro
ugh the
frame
,
l
ocate the
fuse cover attached to the top
of the battery casing.
3
Open the fuse cover
to
exp
ose the fuse.
4
Rem
ove the fuse and replace
with a new one of equal
amperage.
Note:
Amperage rating is
located on
top of
fuse. Fuse
must be replace
d with one of
equal amperage.
5
Close the fuse cover
.
Amperage
number
q
Replacing the Chain
Tools required:
6
mm hexagonal key wrench, 10mm wrench and Phillips screwdriver.
1
Make
sure the power switch
is turned off.
2
Remove the bolt
on the
inside of the rear w
heel.
Remove nut and
pu
ll bolt out
of axle.
3
Remove the 3 screws from
the top half of the chain gu
ard
and remove from frame.
1
Remove the bolt on the
outside of the rear wheel.
5
Spread the chain tensioner
apart to loosen chain.
6
Remove chain from both
spro
ckets and replace with new
chain.
4
Remove the
2
screws from
the bottom half of the chain
guard and remove from frame.
WARNING:
Do not touch motor a
fter use.
Motor is (or can be) very hot.