Need Help? Visit our website for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time. Please have the
product I.D. code (located on the bottom of the frame) available for better assistance.
BEFORE YOU BEGIN
Remove contents from box and check parts against parts diagram found on page 6. Remove the foam separators that
protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint or
dents that may have occurred during shipping. Because the FlashRider 360˚ was partially assembled and packed at the
factory there should not be any problems, even if the box has a few scars or dents.
q Estimated Assembly and Set-Up Time
Allow up to 15–20 minutes for assembly.
WARNING: DO
NOT USE NON-RAZOR
PRODUCTS WITH YOUR
FLASHRIDER 360˚.
The FlashRider 360˚ has been
built to certain Razor design
specifications. The original
equipment supplied at the time of
sale was selected on the basis of
its compatibility with the frame,
fork and all other parts. Certain
aftermarket products may or may
not be compatible and will void
your warranty.
q Required Tools
(2) 5mm
Allen wrenches
(included)
10mm and 13mm
wrench
(included)
PRODUCT I.D. CODE
1.Bottom of Frame
2.UPC Side of Box (not shown)
To Next Page
Loading...
Need help?
General
