5
ASSEMBLY AND SET-UP
2 Place a new cartridge in back of the bracket making sure to align the slots
on the cartridge with the two legs of the bracket. Slide cartridge forward
until you hear a click and the thumb tabs are locked in place.
1 Using your thumbs, press tabs
on both sides of the cartridge to
release from the bracket. Slide
cartridge away from you and
remove from bracket.
q Replacing the Spark Cartridge:
q Using the Spark Handle
SET UP AND USAGE INSTRUCTIONS
WARNING: Pulling
the Spark Handle upwards too
strenuously may cause loss of
control.
NOTE:Sparks and Spark
cartridge life will vary based on
the amount of pressure applied
by Spark Handle, the length of
time pressure is applied and
the smoothness of the riding
surface.
WARNING: Do not
attempt to replace cartridge
immediately after riding as
cartridge will be hot. Handle only
when cool.
WARNING: Keep fingers
clear of Spark Bar hinge.
Friction during sparking will eventually wear out the replaceable cartridge and cause the scooter to stop making
sparks. Worn out cartridges should be replaced.
1 Pull back on the Spark Handle to operate
sparking feature.
NEVER push down directly on the Spark Bar, Spark
Cartridge or Spark Cartridge Cover itself.
1 Using (2) 5mm Allen wrenches,
remove the (4) coupling bolts from
the frame.
2 Align the (4) holes in seat
with the (4) holes in frame. Insert
coupling bolts through the top and
bottom of the frame.
q Attaching the Seat
Required Tools: (2) 5mm Allen wrench
3 Tighten the coupling bolts using
(2) 5mm Allen wrenches.
To Next Page
Loading...
Need help?
General
