Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
BEFORE YOU BEGIN
Remove contents from box and check parts against parts diagram found on page 6. Remove the separators that protect
the components from damage during shipping. Inspect the contents of the box for scratches in the paint or dents that
may have occurred during shipping. Because the RipRider 360˚ Caster Trike was partially assembled and packed at the
factory there should not be any problems, even if the box has a few scars or dents.
Estimated Assembly and Set-Up Time
Allow up to 15–20 minutes for assembly.
WARNING: DO NOT USE
NON-RAZOR PRODUCTS WITH
YOUR RIPRIDER 360˚ CASTER TRIKE.
The RipRider 360˚ Caster Trike
has been built to certain Razor
design specifications. The original
equipment supplied at the time of
sale was selected on the basis of
its compatibility with the frame,
fork and all other parts. Certain
aftermarket products may not
be compatible and will void your
warranty.
1
Required Tools
Two (2) 5 mm
Allen wrenches
10 mm and 13 mm
wrench
Plastic Bag Contents:
• Tools
• Owner’s Manual
Product ID Locations:
See locations to the left
1. Frame (underneath unit)
2. Box - side of UPC (not shown)
To Next Page
Loading...
