A
C
B
26
Make sure to leave plenty of extra webbing for any adjustments that may be
required later then cut off any excess and burn the end to seal it.
The free end of the webbing should be on the underside of the Lumbar Strap
towards the diver and can be held neatly in place with the loop of bicycle tire
inner tube.
Weights can be added to the Lumbar Strap below the Wide Gauge Tri-glide if
required (see Step 9: Weighting and Trim) but it is recommended to use the
T Weight System rather than add weight directly to the Razor Harness itself.
Step 1: Rigging the Razor Harness
4 Rigging the Razor Harness 2.5
To Next Page
Loading...