EasyManuals Logo

RBH Sound UNC100 Axiom User Manual

RBH Sound UNC100 Axiom
25 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
UNC100 Axiom Hardware Manual V1.2 RBH Access Technologies Inc.
Page 7 of 25
Introduction
The UNC100 is a single door In/Out access point controller for the Axiom™ system that includes a built-in
local area network interface.
The network interface also utilizes a POE (power over Ethernet) converter.
ULC-S319-05 III
For ULC-S319-05 III compliance, all wiring into the panel’s cabinet must enter through metal conduit.
Also be sure to mount the panel in a protected area.
Communication
The UNC100 has one RS485 port and an Ethernet 10/100 interface. Communications from the host
computer running Axiom software can be achieved in the following ways; either via the Ethernet
interface or via RS485 through a direct connection to a designated channel. The UNC100’s RS485
channel may be programmed as HOST, DNET, UNC-NET, or LAN. Use the DIP switch to select baud rate
for Host communications as 9600, 38400, 57600, or 115200.
Networks
There are three networks supported by the UNC100 these are:
1) Host Communications through the Ethernet or direct connection.
2) Device Communications for devices such as additional RC-2s starting at address 2, Alarm Keypads,
IOC-16 controllers, and PC100.
3) Controller Communications for controllers such as additional UNC500s or for NC100s via UNC-NET
which is protocol designed for RS485 communications between UNC500s and UNC100s only.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the RBH Sound UNC100 Axiom and is the answer not in the manual?

RBH Sound UNC100 Axiom Specifications

General IconGeneral
BrandRBH Sound
ModelUNC100 Axiom
CategoryController
LanguageEnglish

Related product manuals