RC 30A ES - 05 Programming Instructions

* The ESC can be programmed using the transmitter or an RC Electric parts
Programming Card (Sold Separately). Both methods work but using a programming
card is easier.
Settings / Parameters Table
*The motor will need to be connected in order for the ESC to make the beeps.
A = one short beep ( - )
B = three continuing beeps ( - - - )
C = gradual changing sound + beep ( ～ - )
D = low beep ( ↘ )
E = long beep ( — )
- = pause
Parameter
Settings
Tone Sequence
1
Throttle Range Calibration
A - A - A - A
2
Brake
B - B - B - B
05 Programming Instructions