23
4 Point the remote toward the component to be controlled, enter
the 3 digit setup code.
When you enter the setup code, the remote emits a power ON/
OFF signal. If the component turns ON or OFF, you have
entered the proper code.
If the component does not turn ON or OFF and there is more
than one setup code, press 2 or 3 to select another code in
step 3 or try inputting another code (starting again from step
2).
Some manufacturers use several sets of remote control signals
and the first code may not correspond to your component.
Repeat steps 2 through 4 to assign preset codes for as many
components as necessary.
5 Press REMOTE SET UP to exit the preset mode.
The remote control returns to the previous operation mode.
• When operating a PIONEER’S DVD/LD player, set the
manufacturer code to “111” in the preset mode.
• All codes enrolled in the manufacturer code list can be
set even if a code is not displayed.
• TUNER cannot be preset.
• If no commands are entered the receiver automatically
exits the preset code mode after 20 seconds.
dB
dB
dB
dB
To Next Page
Loading...
Need help?
General
