RCA Audio/Video Receiver User Manual

31
PLAYING SOURCES WITH DOLBY DIGITAL OR DTS SOUND
1 Follow steps 1 to 3 of the playback procedure. (Refer to “Playing
a source” on the previous page.)
1 Turn on the power of the playback component.
2 Turn on the power of the receiver.
3 Press FUNCTION to select the source component you
want to play.
2 Press SIGNAL SELECT to select DIGITAL.
(Refer to “Switching ANALOG/DIGITAL signal input” on the
previous page.)
3 Press 2 to switch the Dolby/DTS mode on.
4 Start playback of the component you selected in step 1.
5 Press VOLUME (+/–) to adjust the volume level.
• When an LD or CD player compatible with DTS is
played back with SIGNAL SELECT set in “ANALOG”,
digital noise is output caused by playing back the DTS
directly (no decoding). To prevent noise, you need to
make digital connections (refer to pages 11) and set
SIGNAL SELECT to “DIGITAL”.
2
35
When playing LD recorded in Dolby Digital
When connecting a DVD/LD player or LD player using the 2 RF (AC-3) output, a
commercially available RF demodulator (RFD-1) is required. The RF demodulator changes the
RF signal to a digital signal which is then processed by the receiver at the digital input jacks.
For more details, refer to the instruction manual supplied with the RFD-1.
2
1
3
2
5
1
memo
MULTI CONTROL
DVD/LD TV/SAT VCR/DVR CD
LOUDNESS FUNCTION MUTING
RECEIVER
D.ACCESS CHANNEL
ATT
VOL
MENU
TOP
MENU
VOL
CH
2 DSP MODE MIDNIGHT 5.1CH
CD-R/
TAPE/MD
CHANNEL
SELECT
CHANNEL
LEVEL
EFFECT
ENTER
ENTER
FQ
FQ
ST ST
FL
DIMMER
REMOTE
SETUP
MASTER
VOLUME
TV CONTROL
FUNC
10 DISC
SIGNAL
SELECT
TEST
TONE
RECEIVER TUNER TV CONT
1234
1 ¡ 4 ¢
7 8 3
5678
90
‡
SOURCE CLASS MPX BAND
PREPROGRAMMED
AUDIO/VIDEO SYSTEM REMOTE
POWER
POWER
POWER
OSR
memo

RCA Audio/Video Receiver Specifications

General

Brand	RCA
Model	Audio/Video Receiver
Category	Receiver
Language	English