Attach the white plug on one end of
the audio/video cable to the AUDIO
IN jack on the TV or VCR.
Note: If your TV (or VCR) has stereo
left and right AUDIO IN jacks, attach the
plug to the one labeled MONO. If one of
the jacks is not labeled MONO, you may
need a Y-adapter, such as AH25 shown
on page 60, to hear both channels.
Attach the yellow plug on the same
end of the audio/video cable to the
VIDEO IN jack on the TV or VCR.
Attach the yellow plug on the other
end of the audio/video cable to the
yellow VIDEO jack and the white
plug to the white AUDIO jack on the
side of the camcorder.
For CC439 model, place the
A V 0 UT/IN switch to OUT.
Playback Operation and How to Copy Tapes on a VCR "_ _'_............._'_...................._.........................
I. A. Camcorder connected directly to
TV monitor: Turn on the TV and
tune it to its video input channel.
B. Camcorder connected to VCR that
is already connected to TV: Turn on
VCR and place it in the "line" or
"camera" mode. (If your VCR does
not have a "line" or "camera"
mode, consult the VCR owner's
manual.) Operate the TV as you
nonnally do to see the signal
coming from the VCR.
2. Press and hold the small button on the
camcorder's CAMERA/OFF/VCR
switch while sliding it to VCR. Insert
the cassette you want to playback (or
copy).
Note: The camcorder can only play back
tapes recorded at the SP speed.
3. Press PLAY on the camcorder. To copy
what the camcorder is playing, place a
blank cassette in the VCR and start the
VCR recording. Adjust the tracking on
the camcorder if necessary. Details are
oli page 49.
• During playback, use the playback
features described on page 49.
4. Press STOP/EJECT when you are
finished.
Watching What the Camcorder is Seeing or Recording on the TV ..............................
l.h.
go
Camcorder connected directly to 2.
TV: Turn on the TV, and tune it to
its video input channel.
Camcorder connected to VCR that
is already connected to TV: Turn on
VCR and place it in the "line" or
"camera" mode. (If your VCR does
not have a "line" or "camera"
mode, consult the VCR owner's
3.
manual.) Operate the TV as you
normally do to see the signal
coming fi-om the VCR.
Press and hold the small button on the
camcorder's CAMERA/OFF/VCR
switch while sliding it to CAMERA.
Insert the cassette you want to
record on.
Note: When the camcorder is used as a
camera, turn the TV's volume down to
prevent a high-pitched squeal caused by
feedback.
Press the camcorder's REC/PA USE
button to begin recording. You can
watch what the camcorder is seeing or
rccordim, on the TV screen.
51
To Next Page
Loading...
Need help?
General
