RCA DRC62705E24G - Using the Remote Control; Battery Replacement

EN - 2
Remote Control
Battery Replacement
When the battery becomes weak, the operating distance of the remote control will be
greatly reduced and you will need to replace the battery.
Note:
• Iftheremotecontrolisnotgoingtobeusedforalongtime,removethebatteryto
avoid damage caused by battery leakage corrosion.
• Whendiscardingbatteries,environmentalproblemsmustbeconsideredandlocalrules
or laws governing the disposal of these batteries must be strictly followed.
WARNING:
• Donotdisposeofthebatteryinareoritmayleakand/orexplode.
• Batteriesshouldnotbeexposedtoexcessiveheatsuchassunshine,reorthelike.
CAUTION:Dangerofexplosionifbatteryisincorrectlyreplaced.Replaceonly
with the same or equivalent type.
Remove the plastic sheet
before operating the
remote control.
To Change Remote Battery
1. Open the battery door.
2. Insert one CR2025 (3V) size battery.
Using the Remote Control
• Point the remote control at the REMOTE
SENSOR located on the unit.
• When there is a strong ambient light
source, the perform ance of the infrared
REMOTE SENSOR may be degraded,
causing unreliable operation.