11
FLASH
Use the FLASH button on the handset to activate custom calling
services such as call waiting or call transfer, which are available
through your local phone company.
TIP: Don’t use the TALK button to activate custom calling service such
as call waiting, or you’ll hang up the phone.
LAST NUMBER REDIAL
To quickly redial the last number you dialed:
1. Press TALK button.
2. Press the redial button.
HOLD
Press the HOLD button to put a call on hold.
To take a call off hold, press the hold button again.
•To switch a call on hold from the base to the cordless
handset, press “HOLD” on the cordless handset.
If you continue the call on a separate extension phone, your
cordless phone releases the line to the extension phone.
PAGING THE CORDLESS HANDSET
This feature helps you locate a misplaced handset.
Press the PAGE button once on the base (25413/25414/25415),
then press number 0 button. The cordless handset will beep
continuously (if it is not out of range) for 2 minutes or until you
press any button on the handset.
NOTE: You may still page the cordless handset even if the ringer is
turned off.
VOLUME ADJUST
Adjust the receiver volume by pressing the Volume Up/Down
button (located at the side of the handset) when you are in talk
mode. There are four volume levels, and each press of the Volume
Up/Down button adjusts the receiver volume by one level.
MAKING AN INTERCOM CALL WITH OTHER EXTENSIONS
1. Make sure the phone is OFF (not in TALK mode).
2. Press the INT button, and the display will show
SELECT
PHONE ID
.
3. Press the number button to input the phone ID you want to
intercom with. For example, to intercom with extension 2, you
need to input "0", "2".
4. When finished, press the INT or TALK button to end up the
intercom call.
NOTE: To cancel the intercom call, press INTERCOM.
ANSWERING AN INTERCOM CALL
1. Press the INTERCOM button or TALK button.
2. When finished, press the INTERCOM button or TALK
button again.
To Next Page
Loading...
Need help?
General
