HANDSET SOUND SIGNALS
Signal Meaning
A long warbling tone (with ringer on) Signals an incoming call
Three short beeps Page signal
One short beep (every 7 seconds) Low battery warning
TROUBLESHOOTING GUIDE
TELEPHONE SOLUTIONS
No dial tone
• Check and repeat installation steps:
Ensure the base power cord is connected to a working outlet.
Ensure the telephone line cord is connected to the base and
the wall jack .
• Connect another phone to the same jack; if there is still no
dial tone, the problem might be your wiring or local service.
• The cordless handset may be out of range of the base. Move
closer to the base.
• Ensure the battery is properly charged (12 hours).
• Ensure the battery pack installed correctly.
•Did the handset beep when you pressed the TALK button?
The battery may need to be charged.
Dial tone is OK, but can’t dial out
• Make sure the type of phone service you are subscribed to is
TONE. This handset is TONE only.
Handset does not ring
• Make sure the handset ringer switch is turned on.
• The cordless handset may be out of range. Move closer to
the base.
•You may have too many extension phones on your line. Try
unplugging some phones.
• Check for dial tone. If no dial tone is heard, see No dial
tone above.
You experience static, noise, or fading in and out
• Change channels.
• The cordless handset may be out of range of the base. Move
closer to the base.
• Make sure base is not plugged into an outlet with another
household appliance.
• Charge the battery.
Unit beeps
•Clean charging contacts on cordless handset and charge
cradle with a soft cloth, remove comma or an eraser.
• See solutions for “No dial tone” on previous page.
•Replace the battery.
To Next Page
Loading...
