21
Memory Dialing doesn't work
•Did you program the memory location keys correctly?
•Did you follow proper dialing sequence?
Unit locks up and no communication between the base and
cordless handset
• Unplug the AC power supply from the wall outlet and the back
of the base. Remove the handset battery. Wait for 30
seconds and plug the power supply back into the base
and wall outlet. Reconnect the battery and charge for 12 hours.
CALLER ID SOLUTIONS
No Display
•Is battery fully charged? Try replacing the battery.
• Make sure that the unit is connected to a non-switched
electrical outlet. Disconnect the AC power supply from the
base and reconnect it.
Caller ID Error Message
• The unit displays this message if it detects anything other
than valid Caller ID information during the silent period after
the first ring. This message indicates the presence of
noise on the line.
No Caller ID
•In order to receive Caller ID information, you must subscribe
to the standard name/number Caller ID service from your
local telephone company.
BATTERY SOLUTIONS
If you experience any of the following problems, even after fully
recharging the battery, you may need to replace the battery pack:
• Short talk time
• Poor sound quality
• Limited range
GENERAL PRODUCT CARE
To k eep your unit working and looking good, follow these guidelines:
•Avoid putting the phone near heating appliances and devices
that generate electrical noise (for example, motors or
fluorescent lamps).
• DO NOT expose to direct sunlight or moisture.
•Avoid dropping the handset, as well as other rough
treatment to the phone.
•Clean the phone with a soft cloth.
• Never use a strong cleaning agent or abrasive powder
because this will damage the finish.
• Retain the original packaging in case you need to ship the
phone at a later date.
• Periodically clean the charge contacts on the handset and
To Next Page
Loading...
Need help?
General
