RCA H5400

13
5. Press the STORE button again to save your selection. The
display shows ENTER LOCATION .
6. Enter two digits to enter the location, range from 01 to 40.
For example, to store the record in location #5, press "0", "5".
After entering a valid location number, the record
will be saved.
7. To enter another name and number in a different memory
location, return to step 1 and repeat the process.
STORING A REDIAL NUMBER
1. Make sure the phone is OFF (not in TALK mode).
2. Press the REDIAL button on the handset to review the
redial number.
3. Press SELECT and
ENTER NUMBER shows in the display.
4. Then press SELECT again and
ENTER NAME shows in the display.
5. Use the keypad to enter the names.
6.
Press STORE button and ENTER LOCATION shows in
the display.
7. Enter two digits to enter the location, range from 01 to 40.
For example, to store the record in location #5, press "0", "5".
After enter a valid location number, the record will be saved.
NOTE : If the number you want to redial has more than 32 digits, the
telephone number cannot be stored in memory.
INSERTING A PAUSE IN THE DIALING SEQUENCE
Press the #PAUSE button on the touch-tone pad twice to insert a
delay in the dialing sequence of a stored telephone number
when a pause is needed to wait for a dial tone (for example,
after you dial 9 for an outside line, or wait for a computer access
tone.) Each pause counts as 1 digit in the dialing sequence.
REVIEWING, CHANGING OR DELETING STORED
NAMES/NUMBERS
To Review: Press DIR/on the handset, then press the or
button to scroll through the stored numbers. Or press the
memory location number.
To Change: While viewing the record, press SELECT/SAVE button.
Follow the steps under Storing a Name and Number in Memory.
To Delete: Press DIR/on the handset or base, then press the
or button (cordless handset) to scroll to a desired memory.
1. While the entry displays, press delete to mark the entry for
deletion. The display shows
DELETE?
2. Press delete again to delete the entry.
DIALING A STORED NUMBER
Make sure the phone is ON by pressing the TALK button on the
cordless handset.
1. Press the DIR button.
2. Press the desired memory location button (01-40). The
number is shown on the display.